Litter Robot 3 Dump Position Fault (2024)

1. Litter Robot III - Dump Position Fault - RobotShop Community

  • May 3, 2020 · Press and hold reset button until it flashes 3x, then release. This video will help you troubleshoot and recalibrate the DFI sensor: https:// ...

  • Hi! I require your help regarding a problem I’m encountering. Description: My litter robot 3 recently started flashing the blue-yellow-green “cannot find dump position” error code and won’t cycle after the cats use it. If I press “reset” and then “cycle” it will cycle as normally (or almost as normally, see below) but when it returns to the home position the same error lights start flashing again. One thing I have noticed is that, when it is cycling and it reaches the end of its first turn, th...

2. Litter-Robot 3: All three lights flashing (Globe position fault)

  • Blue, then yellow, then red (Flashing sequentially, one light at a time): This means the unit cannot find the dump position. · Red, then yellow, then blue ( ...

  • Find solutions for your Litter-Robot 3's three lights flashing position sensors issue. Fix issues with your Connect Upgrade Kit today!

3. Litter robot 3 - dump position fault - RobotShop Community

4. Litter Robot Connect - #59 by LitterRobotFan - Device Ideas

  • Nov 25, 2017 · My Litter Robot 3 Connect which is only 2 months old just started getting the Dump Position Fault. I can clear the fault if I physically ...

  • Did anyone determine how to calculate the UDP Checksum?

5. Litter-Robot 4 Red and Partial White Flashing Globe Position

6. Litter-Robot 3: Fixing the globe magnets

  • Litter-Robot 3: Fixing the globe magnets · Blue → Yellow → Red Cycling: This means the unit cannot find the Dump position. · Red → Yellow → Blue Cycling: This ...

  • Troubleshooting your disassembled Litter-Robot 3 Globe? Our guide helps you check magnet positions and correct errors for a smoothly functioning unit.

7. Litter Robot III Open Air Troubleshooting - All 3 Lights ...

  • Dec 20, 2018 · If necessary, remove some litter from the globe so that the level is an inch below the fill line, then press the Reset button. It's best to ...

  • Check out our video on how to fix the 3 blinking lights on your Litter-Robot Open Air III.

8. Troubleshooting Step-By-Step Guide - Litter-Robot 3

  • Oct 18, 2016 · The unit should perform an initial Clean cycle: the Globe will rotate counterclockwise to the Dump position, then rotate clockwise past the Home ...

  • Our convenient Litter-Robot 3 troubleshooting guide helps solve common and not-so-common problems with your unit. Learn how to quickly fix your Litter robot 3.

9. [PDF] Litter-Robot 3 Manual - EN

  • 3. Place ... You can cancel the timer. (red light) by pressing Reset. Red Light Flashing: Cat Sensor Fault ... Cannot find Dump position. The unit will continue ...

10. Litter-Robot 4: Light Codes Guide

  • If your unit's light bar is blue with two flashing yellow lights, this indicates that the scale has been triggered for more than 30 minutes. Remove excess ...

  • Discover solutions for all Litter-Robot 4 light codes in our comprehensive guide. Find quick fixes and get your Litter-Robot working perfectly again. Click now!

Litter Robot 3 Dump Position Fault (2024)
Top Articles
Latest Posts
Recommended Articles
Article information

Author: Roderick King

Last Updated:

Views: 6098

Rating: 4 / 5 (51 voted)

Reviews: 90% of readers found this page helpful

Author information

Name: Roderick King

Birthday: 1997-10-09

Address: 3782 Madge Knoll, East Dudley, MA 63913

Phone: +2521695290067

Job: Customer Sales Coordinator

Hobby: Gunsmithing, Embroidery, Parkour, Kitesurfing, Rock climbing, Sand art, Beekeeping

Introduction: My name is Roderick King, I am a cute, splendid, excited, perfect, gentle, funny, vivacious person who loves writing and wants to share my knowledge and understanding with you.